New Cougar Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
274 Posts
Discussion Starter · #1 ·
How do remove the 2 vacum lines off of the UIM. Is there a special tool and what does everyone recommend using to clean the UIM out?
 

·
Registered
Joined
·
274 Posts
Discussion Starter · #3 ·
I messed up bad, now i need a new vacum line. It broke off in my hand!!!!
 

·
Registered
Joined
·
4,973 Posts
yea tell me about it. I broke mine off too and I lost my brakes. If you need a quick temporary fix take an empty BIC pen tube and tape it up really tight to the hose and stick it into the UIM. It works. Just be sure to get a new piece from Ford. I think it goes for a little over $20. The only way I can think of taking them off is to detach them not from the UIM, but from the other end.

Mike
 

·
Registered
Joined
·
274 Posts
Discussion Starter · #6 ·
well, im kinda glad im not the only one, is it a hard piece to replace?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top