New Cougar Forum banner

1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
how woould i go about doing this? i want to throw on a carbon-fiber or brushed aluminum kit but i have this wood kit that needs to be taken care of. should i use a heat gun or hairdryer? i clueless on where to start! :)
 

·
Registered
Joined
·
1,029 Posts
Did you install it yourself? It's probably just double sided 3M tape holding it on... You can PROBABLY just pull it off if you're careful. If you don't know what it's held on with, it might be some sort of glue which might be harder to take off...
 
1 - 2 of 2 Posts
Top