New Cougar Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
587 Posts
Discussion Starter · #1 ·
I am think about changing from 99 razzi sides to the 01-02 version. I just don't want to get them and then not sit all that low.

Any pic will help, a pop can for reference or a side shot with an aftermarket bumper. I have a drift front with 99 razzi rear pieces and I just dont want the sideskirts to sit higher than the rest of the car.

Thanks
 

·
Registered
Joined
·
660 Posts
If you look at the picture for the sides on customcougars.com, the pic shows the sides on the car with the drift front and the razzi rear pieces, It is the same car that is in my banner but I chopped it.
 

·
Registered
Joined
·
587 Posts
Discussion Starter · #6 ·
Thanks, George. That pic helps but there is still a little bit of doubt in my mind that the 01 sides will look right with the drift and the 99 rear pieces. The ends of my sides skirts, are just as low or slightly lower than the side of the drfit front bumper, so in other words (look at my avatar) less than a pop can.

Yes Cougaritus is correct that I have the 99 sides currently.
 
1 - 7 of 7 Posts
Top