Hey I've been trying to drill the holes to install my strut bar for the past 20 minutes with no progress. Is there an easier way to drill these holes out? or any tips on what kind of drill bits to use? thanks
When we did this install on my buddy's Cougar, we used a standard titanium bit... took about 20 seconds per hole -- I don't remember the size of the bit, but is was a bit on the large size.
Don't start off with the final drill size, you'll find it much easier if you start off with a smaller drill then progress on to a medium size then on to the finished size. :biggrin:
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to New Edge Mercury Cougar owners and enthusiasts. Come join the discussion about troubleshooting, builds, ZETEC, maintenance, performance, modifications, classifieds, and more!