[THUNDERCAT2K]

I have the pacesetter dual exhaust setup. I am trying to figure out what to do to be able to install the roush body kit. supposedly I have to drop the exhaust tips down a little to make sure the kit fits. Anyone done this, or know where I could go to get this done. also estimated cost if possible. Roush told me their pipe is too small, I have a 2.5 inch pipe theirs is 2 1/4 inch. any suggestions would be very helpful Thank you.

 

[Knibbs]

hmm i thought that the roush had a open back set up like the razzi kit. and if thats the case you should be able to fit those in there. of not then all you should have to do is have them taken down bent a little in , then re welded. the only way to really know is to buy the kit, put it up there to test it out and then bring it to your exhuast guy and see what he can do to help you . im sorry i cant help you all thet much. but it shouldnt cost more than 50-80 bucks. im waiting to see if im going to have to have my exhaust extended to fit my kit. i have 01 razzi kit and singback borla. i know i have to expand the hole, but im not sure yet if i have to extend the pipe to makes sure it clears the kit. i hope not. but good luck

 

[Red2KCougar]

The Pacesetter dual exhaust is 2 1/4" pipe. Maybe you could mod your hangers so that it will come down far enough, the other thing is, the roush rear bumper brings in the outlets, so where your exhaust is comming out now the rear valence would be there, Roush makes a piece that connects to your pipe to bring it in some so it fits. The part is below I am talking about.

Welp, sorry can't put an image here anymore, just click the attachment :-/. That sucks..