New Cougar Forum banner
1 - 3 of 3 Posts

Discussion Starter · #1 ·
Is there a particular order needed to remove the screws in the intake manifold when replacing the intake gasket? I don't have a Haynes or similar manual, and i wanted to know if this task is as easy as one would think. Thanks.

Chip <><

· is a pop sensation
17,170 Posts
It is pretty straightforward, the most difficult part for me was removing some of the screws between the back of the UIM near the firewall(it's a little tight back there). There is a recommended sequence for the bolts, but I don't have it handy.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.