New Cougar Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,139 Posts
Discussion Starter · #1 ·
Yes, I've searched and read the FAQ. I know how to wire the guages fine, it's just I'm pretty dumb on the fact of how you guys ran your wires to the guage pod into the engine for stuff like A/F and vacuum. I'm not quite sure how you got there and what you did to the stock pillar to run the wires. Did you just take it off totally, drill a small hole and poke them through?

I dunno, a quick explanation on what most of you guys/gals did would be pretty cool. I know it's not hard, just don't want to make it harder than it should be (aka destroying stuff I don't need to.)

Thanks obviously. :)
 

·
Registered
Joined
·
3,694 Posts
OOOOOOOOOOOOO That makes sense.....I was having the same question a few weeks ago until I broke the clips off the top of the pillar. So now I know what I need to do when I get it all fixed.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top