New Cougar Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
293 Posts
With your fiberglass hood i would say use the rivets. I have a kam hood with the likt kit. And there is a lot of pressure on the brackets when the hood tops out. If you were to use screws i think they would wear through eventually. Reason being you have to use very short screws so as they don't go through the top of your hood. If it was a stock hood i'd say go for it but with fiberglass??
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top