New Cougar Forum banner

1 - 7 of 7 Posts
N

·
Guest
Joined
·
0 Posts
Discussion Starter #1
well i was just checking GC's website and i run into those 4 bolt plates...and from what i'm reading sounds like they are supposed to be almost universal (with some modifications) for MacPherson strut equipped cars......at least that is my impression from what i read....the plates look absolutely top notch quality

link

what is your guys opinion? I want some adjustable Camber / caster plates but the ones that i see normally available for cougars seem flimsy - at least in pictures...
 

·
T3/T4 60-1
Joined
·
8,015 Posts
won't work because our strut towers are not flat.... unless they make a specific application the GC camber plates wont' work...


HOWEVER, customcougars.com does sell a kit that will work.
 
N

·
Guest
Joined
·
0 Posts
Discussion Starter #4
well i was thinking it was too good to be true.....

btw have you guys tried those plates that customcougars and bat sells? are they good quality? will they whistand the strees of reapeated autox runs? and last will they still fit even with my omp strut bar?

thanks for your replys
 

·
Registered
Joined
·
1,522 Posts
1. have you guys tried those plates that customcougars and bat sells?
2. are they good quality?
3. will they whistand the strees of reapeated autox runs?
4. and last will they still fit even with my omp strut bar?
1. yes
2. yes as good or better than OEM
3. very likely
4. yes, with some grinding to the inside, nothing huge
 

·
Premium Member
Joined
·
1,762 Posts
Originally posted by: Neutrino123

will they still fit even with my omp strut bar?
I just finished a How-to for this... check it out:

OMP FSTB Re-Install Post-BAT Camber Install

Question:
You cannot adjust the BAT's Camber/Caster kit like you can these GC setup's, can you? The GC looks like you can set the camber/caster to pos/neg... (???)
 
1 - 7 of 7 Posts
Top