New Cougar Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
469 Posts
Discussion Starter · #1 ·
I was thinking of getting an MTX ecu because I swaped my tranny, would I also have to wire up the manual wiring harness, considering the tranny connector, and the clutch sensor. Also would i have to get a MTX MAF too? Could I just have the ATX computer reflashed to accept there is no ATX?
 

·
Registered
Joined
·
469 Posts
Discussion Starter · #3 ·
well I did that
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top