New Cougar Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
Hey i got evevything hooked up with ym system, couple of 12s and an amp, eveyrthing is wired except that one big red wire to somehow reach the engine bay? How did all of you get your wire into the engine? Do i have to drill???
 

·
Registered
Joined
·
4,973 Posts
The wire that came in my amp wiring kit was more than long enough to reach the engine bay. If you don't already have a hole drilled under the driver-side dash, you have to drill one yourself. Look above the brake pedal and to the left, or around that area.

Mike
 

·
Registered
Joined
·
378 Posts
another idea is to run the wire underneath the car along the drivers side next to the brake lines...then run it thru the rubber plug in the spare tire area
 

·
Registered
Joined
·
5,443 Posts
should be a hole for it and if not just use a drill and a unibit to make a hole of desired size. Not very hard at all.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top