New Cougar Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,792 Posts
Discussion Starter · #1 ·
Ok i know this is a stupid question but i dont like to just do things without knowing what im doing. I want to change the bulbs that are above the lisence plate, im sure this is unbelievably easy but i went out and tugged at the casing a bit and it didnt budge. I see a small gap on the right side of each bulb location, can i just put a screwdriver up there and pop them down? i would just try it but im afraid id brake it then id look ghetto driving around with a light hanging down in front of my lisence plate. Thanks
 
G

·
i never thought about this .. i would guess its pretty easy, like the rest of the car i'm sure its lego'd together and just snaps in and out
 
G

·
take a screw driver and stick it in that small gap you see. then push it in (theres a clip that sits on the other side that you'll be pushing in). then it should come out easy.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top