New Cougar Forum banner
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
i remember seeing that somone had it up a while back with pictures but im thinking its gone now.
thanks
 
G

·
Discussion Starter · #3 ·
I'd kill for that air dremel in one of the pics on the Streetconcepts site (see link above). Man, I had to use a little dremel, which only reached about 15% of what I needed to cut. Then, I had to hack-saw the rest off.
 

·
T3/T4 60-1
Joined
·
8,015 Posts
I find it quite easy to go around with a "sharp and fairly new" hacksaw blade, just go around the entire seat to score it about .5-1mm then i cut it down, gives a much smoother cut. I also paint the seats with tremclad rust paint when done, which is a very good idea.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top