New Cougar Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
i usually dont post cuz most answers can be found by searching but i was wondering if anybody had a how to on a compressor and clutch install. my pully is tieing up and its not long before it burns up the belt. from the looks of it it seems that you could remove the pulley and take the bolts out that are on the side of the compressor and drop it down but im not sure? any info would be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top