New Cougar Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
219 Posts
Discussion Starter #1
Good day folks. I hope someone out here can assist me. You see back in the late fall I removed my blend door actuator and held the vane up with a small pair of Vise grips. The warm weather is coming back so I decided I would replace the piece. I popped off the pliers before looking where it was clamped to. For the life of me I unable to figure the orientation of the actuator. Would anyone have a picture (it;s behind the glove-box) of the actuator in place so that I can get mined back on. Thanks so much in advance.
 
1 - 1 of 1 Posts
Top