Seen so many pics i thought id post my own :)

[Jordin Jones]

My setup

[nadthomas]

Not bad just looks like it needs a little TLC, and it would be great. Get those cables cleaned up on the driver side with a little black split loom unless those were just temporary. Also, 10 minutes with a scrub brush, some Simply Green, and a garden hose will do wonders for the engine bay.

[CodyTRX]

Not diggin any of the red stuff, but still a good lookin' car.

[Jordin Jones]

Reds my fav color whats TLC?
and are you talking about the bottom left wires? the guy before me made these like custom fog lights one doesnt even work im probably moving these wires permanently considering i live in florida and dont need fog lights

[CodyTRX]

Tender lovin' care!

[Jordin Jones]

Car gets plenty of TLC then lol and plenty of money if you know what i mean >.>
can i get some pics of anyone elses engine bay so i can get an idea of how to clean it up a bit get it more nice looking

[CodyTRX]

Engine bay galore.

[CougarSpaZtic]

I was thinking of doing the same thing with the top part of my dash, but i left that black and did red on the inside and did my gauge piece red as well.. Lovin the rims..

[Blackcoog]

What is the tube that is running back by the brake booster and IAC sensor. See second picture above it's between the EGR and the Brake booster vacuum line. Is it a PCV line? Usually the PCV line is a plastic accordion type tube.

I still don't like that the IAT sensor is stuck into a tube and that tube is connected to the short ram intake. You could plug that hole with a rubber cap. Then cut small hole in one of the red couplers to pop that sensor into the air stream (small enough so the sensors seals the hole and the sensor stays in there without falling out).

[Jordin Jones]

i actually removed the tube you speak of and cut the pipe off it connects to and just stuck the iat straight into the intake but now its giving me an iat high input code and the iat is no longer working .. ? :/
the other tube i think your looking at is actually a tube that goes from the back of the engine into the intake look at pick two the first tube on the right side of the red intake piping. The original tube was shorter and it broke so i just went to autozone and had them cut me a long tube since i didnt know the size and just hooked it on. Very observant.