Acceleration problem - Page 3

SpeedStyle · 06-10-2008, 10:53 PM

I had the exact same problem, i recently moved my imrc under the my intakes tubing and it has not once fallen on its face, and i live in NC and the temps been at 100 lately.I am 100 percent sure it fixed my problem,Although.... i would like a new imrc just because new seems better but, im ok with saving money where i can, especially at 4 a gallon

chip_drive · 06-11-2008, 01:32 AM

Thanks guys, I will definitely give both of the suggestions a shot. Is there any probs I should know about when moving the IMRC? Do all the cables and everything reach?

I am going to drop it hopefully below my K&N system. Thanks again!

06-10-2008, 10:53 PM	#21 (permalink)
SpeedStyle NECO Member Join Date: May 2008 Location: charlotte nc Posts: 75	Re: Acceleration problem I had the exact same problem, i recently moved my imrc under the my intakes tubing and it has not once fallen on its face, and i live in NC and the temps been at 100 lately.I am 100 percent sure it fixed my problem,Although.... i would like a new imrc just because new seems better but, im ok with saving money where i can, especially at 4 a gallon

06-11-2008, 01:32 AM	#22 (permalink)
chip_drive NECO Member Join Date: Jun 2008 Posts: 18	Re: Acceleration problem Thanks guys, I will definitely give both of the suggestions a shot. Is there any probs I should know about when moving the IMRC? Do all the cables and everything reach? I am going to drop it hopefully below my K&N system. Thanks again!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)