Need Help

[unknown2kcat]

Well this past week I got my drift kit and I'm having a pain getting the front bumper on. Here's whats going on, The sides where the bumper meets the fender has no place to drill BUT i can use the old latchs and HOW do you support the middle of the bumper. This is a big problem that I don't know how to fit. On the side note what is the BEST way to install the side scerts. The back bumper only took 30 min. to get on, Why can't the rest be that fast.

Also and pics of your front support bar would be GREAT. THANKS

[ILLicitKougar]

this might help a little

[megail]

all i did to mount my drift front was look for stock holes, then i tapped and had my friend hold the bumper in positon. next i took out a red sharpie and marked the bumper where i was going to drill. i then drilled the holes, and put the bumper on using some small nuts bolts and locking washers. to support the bumper from flexing in the future i used the stock support (that little black piece of metal thats about a foot long and has flat spots on the ends to attach bolts to) and i put it back to where it mounted on the frame and bent the other end flat so that it was on the bumper and repeated the process with a sharpie drill and bolts. i also made my extra supports out of 3/4" width aluminum stock. check the pictures to see if they help any.

[unknown2kcat]

Well what did you use for the front support in the middle and what did you use for material.
thanks for the pics megail