View Full Version : PRT Transmission Mounts
Danef150
05-18-2006, 03:14 AM
I just installed a set of Urithane Filled mounts from pole120 over on ceg and between them and my Stangkiller Tubular LCA's i can dump the clutch at 4-4.5 grand with no wheel hop ! Wohoo the wheel hop monstor has been slain now all i need to do is get the power to put to my built tranny. Maybee now i can get out of the 16's :cry:
If anyone is looking for a way to get urithane mounts its very convenient just go check the CEG groupe buy section
Jameson
StealthyWeasel
05-18-2006, 08:56 PM
you're in the 16's with a modified MTX? that sucks.
Danef150
06-03-2006, 03:15 PM
Dont remind me...i just blame it on clogged manifolds, wheel hop and 120kmiles
StealthyWeasel
06-04-2006, 07:34 PM
theres something wrong with your car man..
perhaps you're a crappy driver or shifter, ja.
did you check to make sure your imrc is fully operational?
Danef150
06-07-2006, 10:54 PM
perhaps you're a crappy driver or shifter?
I have suspected that might be an issue for a while now but im not that bad a driver honestly. My wheel hop was so bad that i broke a flex pipe, i couldnt launch over 1200rpm without massive wheel hop...thats gone now so once i get my bumper put back on...damn animals im itching to see what it can do. Also i think my wires might be bad 120kmiles ! And im about to get rid of the stock manifolds for headers so i hope that my times drastically improve. If i get into the 15-high 14's i will be extremely pleased. Stealthy thanks for blaming it on my car it makes me feel a little better lol.
StealthyWeasel
06-08-2006, 09:38 PM
haha no problem! not always, but most of the time the DIY'ers aren't bad drivers. and your car has a decent amount of mods, making you decently mechanically inclined :)