View Full Version : apex'i rev/speed meter
RioredCoug
10-08-2004, 08:09 PM
i got an apex'i rev/speed meter and i was wondering if i could use the wiring at the guage custer instead of taping my ECU for tach singal and speed signal
Do you think it would work?/
Thanks
BTW.....Does anyone have one???
01blkcat
10-08-2004, 08:29 PM
Wire it properly, not half-a$$ed. Run the wiring to the ECU where it belongs... it will be a more accurate, stable signal, and it will actually give more than a pseudo-reading.
RioredCoug
10-09-2004, 01:09 AM
yea well my car is in the shop as i type to get a new ECU so im not as excited as you about cutting brand new wires
BTW...whjat is puesdo-readings
01blkcat
10-09-2004, 01:12 PM
Psuedo = false.... so false readings.
If your car is in the shop because of something you did to the ECU, perhaps you should have another member who has done at A/F installation or the like tie into your lines. If it's for any other reason, it's not hard, and with a little patience, you'll tap the two lines you need.