View Full Version : Diamond Plate FL.Mats
RadsCougar
04-12-2004, 08:33 PM
Made this Yesterday,Cut it from the pattern of stock one.The pic looks like it's bent funny put it fits pretty good.Painted it W/dupli-Metal cast.and put 20 coats of clear on it.See if it holds up. This is the pass.side.On the drivers side I might try to cut out the Heel pad and put some black rubber in.Not sure..
CougarSVT
04-12-2004, 09:34 PM
Looks good!! 20 coats of clear coat huh, did you go a little overboard!?!
99CouGSweetRide
04-13-2004, 12:24 AM
cool. guaranteed they'll still get scratched up tho, unless you don't have them in all the time.
Mike
PeDL2DaMeDL
04-13-2004, 02:30 AM
those look hot dude, how did you bend them, a mallet?
PGCougar
04-13-2004, 02:54 AM
:bowdown: VERY NICE!!
RadsCougar
04-13-2004, 07:40 PM
I know that they will still scratch but only the clear coat.So every so often I will lightly sand out the scratches off the clear coat and put another coat on them.As far a bending them I bent it over my knee and with a rubber mallet on the side.I will take a pic.of the driver side w/the heel pad cut in once I get it done hopefully this weekend.