Razzi high rise and drilling new holes?

[silverfrost99]

I bought a razzi high rise and i thought the two holes towards the back were the same as the stock holes, well they are not. I knew i had to drill a hole on each side to be able to attach the front part of the wing. Should I drill three holes on each side for the holes that are in the wing or should i just drill the front two and use self tapping screws at the stock location. I think it would be a pain to drill three hols on each side, but dont know if the self tapping screws will be okay.

Thanks

[99CouGSweetRide]

OK I also have the Razzi wing, and I had a stock spoiler. The stock holes did not match up as well. You have two choices: you can either drill new holes in the spoiler that match up to the stock holes, or you can drill new holes in the trunk altogether. You're gonna need to drill those two extra holes for the front of the wing anyway...but it's up to you. Drilling into the spoiler would probably be better and easier (less holes in trunk and easier to drill through the wing than the trunk.)

Mike

[tropiccougar01]

Perfectly said. Just use the stock holes and drill into the spoiler, plus the 2 holes up front.

[Cougaritus]

Put them in the spoiler man... forget drilling extra holes in the trunk... they might leak if not sealed all the way.... The spoiler can handle the extra holes....

BTW i remember i forgot to include the screws... if u want em I have no problem throwin them in the mail for you...

[silverfrost99]

The only concern I had drilling the spoiler out was that the holes would not be threaded. I would either need to get the tapped or use self tapping screws, but that is what I am going to do.

[ZEXCougar]

Plus, this way you don't have to get the holes in your trunk filled and painted. I had no idea how much this was going to cost until I replaced my spoiler... Let's just say that there are still rubber patches over the old holes and I haven't gotten them fixed yet.