View Full Version : Trade my T3/T4 for a Super 60 Turbo??
naynay
10-03-2003, 08:26 PM
What do you guys think. The Super 60 will spool MUCH faster than the "kinda large" T3/T4. I think it would be a good move for these kits i will be making. Comments?
pgtatx
10-05-2003, 05:43 AM
A T3 Super 60 trim Turbo would be much better for our engines...
DemonSVT
10-06-2003, 04:20 AM
Too small IMO.
It would make decent power under the curve, but be all done before 6000 rpm.
It flows a little less air than a T28 and would require greater boost pressure to achieve it.
A T3/4 hybrid is actually not a bad choice, but there is really only 1 trim well suited for a 2.5L engine. (2 for a 3L)
What trim do you have???
naynay
10-06-2003, 03:38 PM
50 trim......but since im going to have a hard time with tuning past 6000RPM, wouldnt the Super 60 do the job.
DemonSVT
10-07-2003, 03:23 AM
Originally posted by: naynay
50 trim......but since im going to have a hard time with tuning past 6000RPM, wouldnt the Super 60 do the job.
Why are you going to have a hard time tuning past 6000rpm???
The 50-1 trim is okay, but really is meant to be run at higher boost pressures. It is not very efficient at all under 10psi. Also it should be used on a larger displacement engine.
This is the turbo they picked out to run at only 5psi in this vaporware kit. I can't even start to explain the logic behind that...
The T3/4 I'd run on the Duratec is the 54-1 trim. Though the 57-1 trim is not a bad choice if you run in the 10psi and up range.