Bayeri
06-24-2003, 03:38 AM
i have dual jlw3v2's and i need to bridge them at 1 ohm to run on a mono channel amp. can somebody ship up a diagram?
they terminals are as follows
+ +
+ +
SUB
- -
- -
Lukydogg
06-24-2003, 04:41 AM
all the info you need (http://www.jlaudio.com/tutorials/wiring/index.html)
Bayeri
06-29-2003, 08:07 PM
alright so i looked at the diagram you gave me for the
"2 DVC drivers with Voice Coils in Parallel / Parallel
Connecting the voice coils of each driver in parallel (+ to +, - to -) and the drivers themselves in parallel (+ to +, etc.) will result in the following impedances:
Dual-6 Ohm Subwoofers: 1.5 Ohms
Dual-4 Ohm Subwoofers: 1 Ohm
Dual-2 Ohm Subwoofers: 0.5 Ohm"
i get all the wiring on teh actual subs, BUT when the subs are hooked up to the amp, are the pairs of + and - wires spliced togehter? or are they going to 2 seperate - + on the amp?
thanks
andrew