Junior
01-26-2003, 03:36 PM
i have an eclipse 32430 amp, it's 4-channel. i think 800 watts, but i don't know any specs on it. i want to run it on 2 10" subs, can that be done by bridging it? and what kind of subs do i need? 2ohm or 4 ohm? thanks
blast
01-26-2003, 11:22 PM
here are the specs:
200W x 4 Channel Max. Power Output at 2Stereo
120W x 4 Channel 0.1% THD at 2Stereo, 20-20,000Hz@13.8V (RMS Continuous Power)
85W x 4 Channel 0.1% THD at 4W Stereo, 20-20,000Hz@13.8V (RMS Continuous Power)
ChannelFlex Crossover Adjustable Low-Pass Crossover (12dB/octave, 50-200Hz) Adjustable Pre-Out High-Pass Crossover (12dB/octave, 50-200Hz)
Free-Flow Signal Circuit
Double-Sided PCB
High-Current, High-Speed Output Devices
High-Efficiency, High-Energy MOS-FET Power Supply
Audiophile Grade Component Selection
Intelligent 7-Way Discrete Protection Circuitry
Music Reproduction with Low Distortion & Ultra-Low Negative Feedback
Efficient Cooling with Low-Profile Heatsink
Multi-Mode Configuration
Stereo/Mono Switch
2 ohm Stable Design
2ohm or 4 ohm, either way it will work fine. it is 2 ohm stable.