View Full Version : Pre-cat gutting question...
rastaman
10-22-2002, 10:08 PM
I'm askin you guys cuz i know you recently had your cat gutting meet ;) I searched and found the schematic for the MIL Eliminators...building it seems pretty trivial (1 megaohm resistor, 1 mircofarad cap) and splicing it into the sensor...but how did you guys protect the circuit so to speak...did you case it in anything? any special kinds of resistors or caps for this presumably high heat application?
thanks!
ajay
kilkenny
10-23-2002, 04:31 AM
just used the part #'s listed on the teamneco website, and i wrapped mine in 3 different kinds of tape, to protect them from water and heat, hopefully it'll hold
spooki
10-23-2002, 04:37 AM
i just taped mine too
but i was thinking of wrapping it with that black plastic stuff you wrap wiring harnesses with
i think as long as its water tight you should be ok
CougarKontrol
10-23-2002, 02:07 PM
i THINK AS LONG AS YOU DON'T PUT THE mil NEXT TO THE o2 SENSOR it shouldn't get hot enough to melt the solder. then again I don't REALLY know. sorry about the caps, I'm at work and they're always on here.