View Full Version : need help
alley
05-29-2008, 11:24 PM
doing a torsen install.... the bearing (bell housing side) on the gearset without the input shaft is damaged. is this part avalible? if so does anyone have the part number? thanks
david
B3NN3TT
05-29-2008, 11:34 PM
See the sticky at the top of this forum called "MTX-75 parts list"
It lists the part numbers and prices for EVERYTHING.
BTW, the bearings for the output shaft are about 14-15 bucks each. F8RZ-7F431-BB and F8RZ-7F431-AA, front and rear.
alley
05-29-2008, 11:38 PM
ok, i did look at the parts list but i just wanted to make sure. but it is an output shaft bearing? just want to make sure, also is the bellhousing side the front or the rear
B3NN3TT
05-29-2008, 11:46 PM
Good question. The list specifies "grooved" and "ungrooved", so that should tell you what you need to know.
alley
05-29-2008, 11:57 PM
didnt see any grooves but thanks for the input. now i just hope a dealer near by has them
alley
05-30-2008, 06:33 PM
no go at the dealership.... does anyone have a spare mtx-75 that is willing to sell
B3NN3TT
05-30-2008, 07:37 PM
no go at the dealership.... does anyone have a spare mtx-75 that is willing to sell
Where are you located?
Frosty
05-30-2008, 07:42 PM
He's here in IL, a few towns over from me.
B3NN3TT
05-30-2008, 08:52 PM
I see. Because I have one; but I don't care to bother with shipping it. I had a buyer interested, but I've not heard from them in a couple of months.
alley
05-30-2008, 09:35 PM
if you got one together ill come pick it up tomorrow. how much and where do you want to meet
fornetti14
05-31-2008, 09:09 AM
I have a spare diff. & all the bearings and I'm over in Grand Rapids. Too bad I didn't see this earlier because I was just at the Cubs game yesterday! It was awesome!:)