- SCT Chip Problem
- Adjusting rev down/idle issues
- svt pcm in a cougar?
- Xcal 2 ?
- MIL eliminators
- lock xcal2
- transfering tables with an X-cal
- turning things off
- quick question
- Numbers
- Laptop+soft instead of ECU
- ECU four letter code.
- COP and tuning
- SCT Flash Device
- Retunning an ADC Chip
- haha heres a new one
- Superchip
- timing
- how to tune your ecu?
- Newbie offering thanks and my journey.
- DTC's came back
- I bought a chip on ebay...
- X-Cal2
- I purchaced a mod chip need HELP!!!
- Has anyone used Sniper tunes?
- Wideband Oxygen Sensor Resources
- Surge Performance Chip
- x cal2 help
- how chippable are cougars?
- Enginuity. does it work with cougars?
- sct live wire
- Turbo tuning 2.5L returnless...3L parts???
- Deleting CEL codes
- Need Help !!!!!!!!!
- anygood?
- whats the easiet way make ur 00 v6 cougar faster thats cheap?
- Need a little help with tuning...
- performance chip
- Xcal2
- Question about XCal2 tunes
- SCT Chips and the stock ECU
- jet chip and tune diff from 00 to 02?
- Dyno/Tuning issues...
- Needs Advice
- SVT tune for an ATX?
- Leads?
- Superchip part number?
- 'Chips'...
- Adaptive Fuel Table ?
- 3L's done... gonna need a tune.
- Nitrous Tune
- Whats the ideal exhaust setup for my circumstance?
- wideband 02
- need a pic
- Need Tune
- megasquirt
- I came to you cause i have no idea.....
- Question about shutting certain systems down in tune...?
- Dealer software up and running
- compression / oil pressure
- what will a 3.8 mustang maf do
- Clutch switch rev limiter during shifts?
- Need timing advance or retard... or am I off
- Cooling fans don't run after Xcal install
- Would This Do Anything?
- J2534 Flash cable
- xcal2 questions
- Tuning for European gas...
- 65mm TB = throttle hang?
- Dyno Pulls with an ATX
- Lower O2 Sensors
- tuning for turbo
- Question on plenum size in the 2.5l intakes
- Looks like I finally have my greddy
- Tuning buddy needed
- What parameters to datalog for a tuner?
- xcal question
- Spark advance *NEW datalog pic*
- Figuring out pinouts on my PCM
- Recalbrating Needles
- a guy.. whats his name.. warmonger.. yea hes good at tuning
- DIY Info Gauges/ECU Tuning
- Idle Speed (RPM)
- Pats VS SCT
- Apexi
- New dynotune from Logan Motorsports.
- com port or USB
- Boost Switching & PCM Calibration
- Trw3 & Trw7
- AEM UEGO Controller
- help
- maf location
- SVT Program
- PCM code is "USES" :?
- running lean
- Tuning a Duratec...W.T.F???
- help, I'm an idiot
- Dyno tuning Nov. 1
- XCal 2 User Controls
- MPV Dyno Tune 16/10