NECO Forums - View Single Post - How To: End the ATX 1-2 Bang Shift!!!

94lt1 · 03-03-2008, 04:44 PM

Well I got the sensor and installed it. Battery was unhooked and everything reset and sure enough it is still there. I notice when I put it in drive it will buck into gear at times but other gears are fine. The fluid seems good doesn't smell burnt but I was gonna change it anyway cause I am not sure when it was done last. There is no slipping that I can feel. It is only a hard shift between 1 and 2 with a little buck when downshifting into 2 on throttle. I was thinking maybe a roll resistor mount?? The front one looks okay but I haven't looked the back yet. I will reset the computer one more time but I don't think it will help.

03-03-2008, 04:44 PM	#71 (permalink)
94lt1 NECO Member Join Date: Nov 2007 Posts: 5	Re: How To: End the ATX 1-2 Bang Shift!!! Well I got the sensor and installed it. Battery was unhooked and everything reset and sure enough it is still there. I notice when I put it in drive it will buck into gear at times but other gears are fine. The fluid seems good doesn't smell burnt but I was gonna change it anyway cause I am not sure when it was done last. There is no slipping that I can feel. It is only a hard shift between 1 and 2 with a little buck when downshifting into 2 on throttle. I was thinking maybe a roll resistor mount?? The front one looks okay but I haven't looked the back yet. I will reset the computer one more time but I don't think it will help.